Foreign Parts Distributors

Late style vw throw out bearings are a must to replace when seperating the motor from the trans. When inspecting your old bearing, make sure to check out how it attaches to the throw out arm. Late style bearings have clips that are built into the bearing and the ears on both sides are flat. These are also aligned on the pressure plate with a tube that is bolted to the back of the bellhousing that allows the throw out bearing to glide back and forth on. Also if your pressure plate has a ring in the center of it then this isn't the correct bearing and you will need to get a early style. Since parts can be interchanged between both swing axle and IRS transmissions it is very important that you look at this before ordering. We cannot always be 100% accurate based on transmission types alone when ordering. Beetle Type 1: 70-79 Bus Type 2: 70-75 Transmission Type: IRS

VW fuel hose. 7 x 2mm. Sold Per Foot Please order the length you would like by specifing quantity as feet. We will cut this to that length OD: 7mm ID: 2mm Length: 1'

Mechanical fuel pump. Late model with alternator. Gaskets included. Alternators came factory after 73 but it is very common to have one on that is aftermarket. If your not sure if you have a alternator or generator just look at the shape of it. If it is one diameter all the way from the front to back then it is a generator. If it is bigger in the front by the pulley and smaller where it attaches to the fan then it is a alternator Beetle Type 1: 73-74 Push Rod Length: 4 inches Style: Alternator

German VW brake hose. 1 Meter length 7x3mm German made Cloth Braided Brake Fluid Hose is made specifically for brake fluid so it will not break down when exposed to brake fluid like standard rubber hose will. The braided brake fluid hose is used on 1967 through 1977 VW Standard Beetles, 1971 through 1979 Super Beetles, 1967 through 1974 Karmann Ghias, 1967 through 1973 Type 3s and 1973 through 1974 Things. The braided brake hose was originally blue however the manufacturer has recently changed the hose to a black compound Length: 1 METER

Complete beam for ball joint front end. These units are good quality take offs and are complete from spindle to spindle. NOTE: We make every attempt to check each and every beam before it leaves for quality. Since these are take-offs we cannot accept returns for the ball joints being worn or to loose NOTE: Some people have been confused with the term Take Off. This just means it was removed from a Beetle that was in good working order, cleaned up and imported into the states. They are basically good USED units